denoonsp - Home of the modified 400F

Advertise here.

 

 

Products - All Prices listed are in US Dollars

CB400F Rearsets

SOLD OUT - I've been working hard on a set of high quality, affordable rearsets for the 400F.

Machined Triple Clamp

Remove the stock handle bar mounts and add some flash at the same time. Pair that with a set of Tarozzi clip-ons for a sweet combo.

Front Engine Mounts 

 

 CNC motor mounts are manufactured from 6061-T6 aluminum, and clear anodized to prevent corrosion. Complete with hardware. SOLD OUT, I will not be making these once existing stock is gone, unless someone wants a custom one-off piece done to their specs

Rear Engine Mount 

  

 Rear mount is also manufactured from 6061-T6 aluminum, and is a direct replacement for the stock mount. Incorporates the mounting point for the stock air box. SOLD OUT, I will not be making these once existing stock is gone, unless someone wants a custom one-off piece done to their specs

Starter Motor Blanking Plug 
    

Ditch that Starter Motor and fill the hole with a Blanking Plug. SOLD OUT. I will not be making more of these

Kick Start Blanking Plug 
    

If you are racing and want to get rid of the kick start to go "bump start" only, you'll need a Kick start Blanking Plug. SOLD OUT. I will not be making more of these.

 


DISCLAIMER OF WARRANTY -  FOR OFF ROAD USE ONLY

THE PURCHASER IS RESPONSIBLE FOR DETERMINING THE SUITABILITY OF ANY AND ALL PRODUCTS PURCHASED.

All denoonsp parts are sold “as is” without any warranty of any kind. All implied warranties, including all warranties of merchantability of fitness for a particular purpose are excluded.

Purchaser acknowledges that vehicles equipped with these parts must not be operated on public highways since such operation may be unlawful. These performance parts are intended solely for use on vehicles participating in off highway competitive events.
Purchaser understands and recognizes that off road and racing equipment and services provided by manufactured and/or sold by Distributor are subject to varied conditions due to the manner in which they are to be installed and used.  Purchaser further recognizes and agrees that suitability of any part sold or manufactured for a particular application is the purchaser’s decision and that the purchaser is not relying on the skill or judgment of manufactured and/or Distributor regarding suitability of any product or service.
Manufacturer and Distributor make no warranties whatsoever, expressed or implied, oral or written to purchasers with regard to off road and racing equipment.  The right to make changes in design or add to or improve on product without incurring any obligations to install the same on products previously manufactured is expressly reserved.
Buyer agrees to indemnity and hold seller harmless from any claim, action or demand arising out of or incident to the buyer’s installation or use of products purchased from Manufacturer and/or Distributor. 

WARNING: Installation of any component or kit should only be performed by persons experienced in the installation and proper operating of vehicle systems.  

 

Copyright © 2004 DENOONserviceprovider. All rights reserved.
This website was powered by Ewisoft Website Builder.